1
/
of
4
King Gubby
Aufero Laser 2 (LU2-2) Stackable Brick Feet
Aufero Laser 2 (LU2-2) Stackable Brick Feet
Regular price
11.600 Ft
Regular price
Sale price
11.600 Ft
Unit price
/
per
Couldn't load pickup availability
|
Secure your Ortur/Aufero Laser 2 (LU2-2) laser engraver's feet while easily raising and lowering the height of your entire laser. With our stackable "brick" feet, just add or subtract Duplo Lego blocks to change your laser's height as needed. Super simple to use and compatible with the Duplo Lego 2x4 bricks that your child has lying around their room. Bricks can be found here
Watch the video here (the video is for the pro model bricks but shows the overall install and utility of this product as well).
Uses 2x4 blocks (Lego Bricks not included) These work with the large style bricks. Set of 4 feet Screw bottom plates to your table or surface, put the KGD brick tops on top of the, now secured bottoms. Then place the holes in your Aufero Laser 2's (LU2-2) stock feet over the holes in the tops of our bricks and screw down with provided M5 screws. Now, simply add blocks/bricks to the top until you reach your desired height. Make sure all four brick stacks are even and lower your laser onto the top of the bricks, making sure to align the mounted KGD brick tops with the Duplo stacks.
The holes on the outside of the feet are 4mm and the 4 inside holes are 3.8mm in diameter and the plate is 3mm high
NOTE - LEGO BRICKS NOT INCLUDED - If you need bricks, they are HERE
**THIS IS FOR THE AUFERO LASER 2 (LU2-2) ONLY
TIP -To increase your production rate, you can buy multiple sets of the brick bottoms to quickly exchange waste boards and have them pre-prepped.
|
Share
