1 7

King Gubby

Ortur Laser Master 3 Stackable Brick Feet

Ortur Laser Master 3 Stackable Brick Feet

11.700 Ft
11.700 Ft
Sale Sold out
Extra Bottom Set for Additional Waste Board?
Secure your Ortur Laser Master 3's feet to your waste board with these stackable brick feet. Just add or subtract "kids Bricks" to change height as needed. Super simple to use and compatible with the larger toy stackable bricks/blocks your kid has lying around the house. Bricks can be found here
NOTE - These feet will not work with the LM3 LE model

Watch the video here

  1. Are the King Gubby Stackable Brick Feet compatible with all building bricks?
    No, they work with DUPLO Legos or any similar sized, off-brand bricks. However, it is best to check the specifications of the bricks before purchasing to ensure compatibility.

  2. Can I use the Ortur Laser Master 3 Stackable Brick Feet without bricks?
    Yes, by using the feet without any bricks, you will still have the sturdiest retaining feet on the market for your Laser Master 3.

  3. How many bricks do I need for the Ortur Laser Master 3 Stackable Brick Feet by King Gubby?
    The number of bricks required for the Stackable Brick Feet depends on the height you want to achieve. It is recommended to purchase a few extra bricks in case you need to make adjustments in the future. Each brick is 3/4 of an inch high (19mm). 19mm divided by the height of the object you are trying to get under your laser, when focused, will give you the number of bricks you need.

  4. How many bricks do I need for the King Gubby Brick Feet to use the rotary accessory?
    King Gubby recommends eight bricks per foot or thirty two bricks total to raise your laser high enough for engraving tumblers. Keep in mind, this is a general estimate, as there are different types and sizes of tumblers on the market, and they all require different heights. Please refer to question three to get your exact measurement needs.


Uses 2x4 blocks (Lego Bricks not included) These work with the large style bricks.

Set of 4 feet

Screw bottom plates to your table or surface, add blocks/bricks to the top until you reach the desired height. Make sure all four brick stacks are even. Screw the King Gubby Stackable Brick Foot Top to the underside of your LM3 with the provided screws. Then place your laser on the top of the brick stacks, making sure to alight all of the secured brick tops with the tops of the stacks. That's it!

The holes on the outside of the feet are 4mm and the 4 inside holes are 3.8mm in diameter and the plate is 3mm high


NOTE - STACKABLE BRICKS NOT INCLUDED - If you need bricks, there are HERE


TIP -To increase your production rate, you can buy multiple sets of the brick bottoms to quickly exchange waste boards and have them pre-prepped.

View full details