Get cleaner engravings and overall better performance out of your laser. Expect deeper cuts by removing the debris and quickening your burn with our Low Profile Air Assist. If you have shop air, we recommend between 15-25psi. Small pumps will show great improvement as well. If you need an air pump, you can find them here.
Ortur Laser Master 2 - Air Assist. This is for the STANDARD LASER MASTER 2 and does not work with modules other than the LU1 models.
Tools Required: 2mm allen wrench
Install: -Attach joint pieces and nozzle to square frame -Install the Joint attachment to your cooling block using the 2 supplied M3 screws (see photos) -Install your 6mm hose (optional) -Guide Hose under and up to the stepper area -Secure hose with zip ties to the wire loom -Place Nozzle at 45 Degrees 2-3mm from laser dot on workpiece.
*The laser and hose shown is for illustrative purposes only and is not part of the offer.
