Skip to product information
1 of 6

King Gubby

Ortur Laser Master 2 Stackable Brick Feet

Regular price
$28.99 USD
Regular price
Sale price
$28.99 USD
Secure your Ortur laser engraver's feet while easily raising and lowering the height of your entire laser. With our stackable "brick" feet, just add or subtract blocks to change your laser's height as needed. Super simple to use and compatible with the super common children's 2x4 bricks that your child has lying around their room. Bricks can be found here

Watch the video here (the video is for the pro model bricks but shows the overall install and utility of this product as well).

Uses 2x4 blocks (Lego Bricks not included) These work with the large style bricks.

Set of 4 feet
Screw bottom plates to your table or surface, add blocks/bricks to the top until you reach the desired height. Make sure all four brick stacks are even and place KGD branded top brick on top. Then place your (STANDARD) Ortur Laser Master 2's stock feet into the slits on the top.

The holes on the outside of the feet are 4mm and the 4 inside holes are 3.8mm in diameter and the plate is 3mm high



**THIS IS FOR THE STANDARD LM2 ONLY
-
TIP -To increase your production rate, you can buy multiple sets of the brick bottoms to quickly exchange waste boards and have them pre-prepped.
---
NOTE - STACKABLE BRICKS NOT INCLUDED - If you need bricks, there are HERE
NOTE 2 - THE ACRYLIC FOOT IN TOP OF THE STACKED BRICKS (IN THE IMAGES ABOVE) IS NOT PROVIDED AND IS FOR ILLUSTRATIVE PURPOSES ONLY. IT SHOWS HOW THE FOOT OF YOUR LASER WILL SIT IN THE BRICK SLOTS.